OP02-KHAS（SPEC40425）
OP02-KHAS
320,000円 （税込：352,000円）
- Resistive load device that confirms the operation of the “harmonic current/flicker measurement system” performs properly.
- The OP02-KHAS(SPEC40425) is able to perform the daily check of the harmonic measurement standard “EN/IEC61000-3-2”, “EN/IEC61000-3-12”, and the flicker measurement standard “EN/IEC61000-3-3”, “EN/IEC61000-3-11” for the “harmonic current/flicker measurement system”
カート機能が動くまでの
Overview
Daily pre-test checker
The OP02-KHAS(SPEC40425) is the resistive load device that confirms the operation of the “harmonic
current/flicker measurement system” performs properly. The OP02-KHAS(SPEC40425) is able to perform
the daily check of the harmonic measurement standard “EN/IEC61000-3-2”, “EN/IEC61000-3-12”, and the
flicker measurement standard “EN/IEC61000-3-3”, “EN/IEC61000-3-11” for the “harmonic current/flicker
measurement system”
Open in a new windowZOOM
| Operation mode | Harmonic mode / Flicker mode |
|---|---|
| Control type | Resistive load method (forced air cooling) |
| Input voltage range | Single-phase 100 VAC to 240 VAC |
| Input voltage type | Single-phase two-wires, Single-phase three-wires (change by per phase), Three-phase four-wires (change by per phase) |
| Input current | 2.3 A ±5 % (when at the setting voltage of 230 V), 1.0 A ±5 % (when at the setting voltage of 100 V) *Maximum power when through the phase contorl |
| Allowable current for the external load connecting terminal | Approx. maximum 10 A |
| Harmonic generation method | Phase control |
| Phase angle variation range | Approx. 10 to 170 (when at the setting voltage of 100 V or 230 V) |
| Thermal protection | Yes (ALARM lights on, a buzzer sounds) |
| Flicker generation method | Square-wave ON/OFF control by the electronic timer |
| Flicker frequency setting range | Approx. 0.5 Hz to 20 Hz |
| Warm-up time | Approx. 10 minutes |
| Power supply for the activation | Single-phase 86 VAC to 264 VAC, less than 75 W (possible for common use of the measurement circuit) |
| Withstanding voltage | Between the Input and FG(Frame Ground) 1830 V, less than 5 mA |
| Dimensions | 214(W)×124(H)×400(D)mm (Excluding the projected components) |
| Weight | Approx. 6 kg |
